Chevrolet Epica mat emulator - installation
1. Turn the ignition off.
2. Under the passenger seat, locate the mat connector with 3 wires: white, red, brown (from the mat side). On the car installation side, the colors of the wires are different.
3. a) If the emulator ended with terminals:
Remove the wires from the mat plug in the car (e.g. using a small screwdriver to press the pins) and replace them with the emulator wires in the same color order. The seat mat remains disconnected and the emulator is connected in its place.
b) If the emulator is ended with a plug:
Just unplug the mat connector and replace it with the emulator plug.
4. Turn the ignition on and wait for a while.
If the airbag light has gone out by itself, you don’t have to do anything else.
If the indicator does not go out, you need to remove the fault code using an appropriate diagnostic software.